PDS/PDMS Designer - Electrical
at
Fluor Daniel India (p) Ltd
, New Delhi
Working/Currently
I have five years experience in electrical design calculations,
detailed engineering, 3D modeling & preparation of following
drawing/documents for Oil & gas, Chemical plants and power plant
projects.
Experienced in 3D Modeling of cable trays,
underground cable trenches, duct banks, Motor control stations,
various type of light fixtures, welding/convenience receptacles,
Junction boxes, Other Electrical equipments, 2D drawing
extraction from 3D model, interference clash check with other
discipline and resolving the clashes using PDS/PDMS
software.
Experienced in lighting design for Indoor, outdoor
and road lighting by using various lighting design software &
preparation of lighting layout.
Experienced in cable sizing
and voltage drop calculation.
Transformer and emergency
diesel generator sizing calculation based on load
analysis.
Battery, Battery Charger and UPS sizing
calculation.
Fault level (Short circuit) calculation & Earth
bus and Neutral bus sizing.
Hazardous area classification
layout and selection of electrical equipment.
Lightning
protection risk assessment calculation.
Preparation of
Electrical load schedule.
Preparation of Interconnection
block diagram and cable schedules.
Preparation of substation
layout based on requirement and standards.
Preparation of
single line diagram and Protection & metering block
diagram.
Preparation of cable tray/trench
layout.
Preparation of earthing and lightning protection
layout.
Preparation of electrical installation detail
drawings.
Preparation of cable schedules and
MTOs.
Inter discipline drawings review